B&G H5000 Pilot Computer - Manual (Page 43)

| 43 Operation | H5000 Operation Manual
H5000 Pilot Controller
3 5
4
c
7
e
6
b
1
8
2
d
f
a
Display
The displayed information will change depending which mode is selected.
X Description X Description
a Performance level d Target
b Autopilot mode e Compass: ºT = True ºM = Magnetic
c Rudder angle indicator f Heading
Keys
The H5000 Pilot Controller is operated by 8 keys. These are used to operate the autopilot and
adjust autopilot parameters.
1 MODE
Changes the autopilot mode / Scrolls up in menu options / Increases values. With active autopilot:
Toggles between Wind mode and Auto mode
2 10º COURSE CONTROL STARBOARD (10º RIGHT)
Changes target course 10º Starboard
3 1º COURSE CONTROL STARBOARD (1º RIGHT)
Changes target course 1º Starboard / Activates Non Follow Up (NFU) mode when in Standby mode /
Enter menu
4 10º COURSE CONTROL PORT (10º LEFT)
Changes target course 10º Port
5 1º COURSE CONTROL PORT (1º LEFT)
Changes target course 1º Port / Activates Non Follow Up (NFU) mode when in Standby mode / Exit
menu
6 STBY
Disengages the autopilot
7 AUTO
Engages the autopilot
8 MENU
Enter the Main menu / Scrolls down in the menu options / Decreases values. Press and hold for 3 secs
enters the lighting settings
.
Warning: The installation settings must be performed as part of the
commissioning of the autopilot system. Failure to do so correctly may
prohibit the autopilot from functioning properly! The Installation menu
can only be accessed in Standby mode.