B&G H5000 Pilot Computer - Manual (Page 38)

38 | Operation | H5000 Operation Manual
Stop
Stops the timer. Press
the ENTER key again to restart the timer.
Reset
If the timer is running, selecting reset will automatically start counting down from the
originally set value for the race timer. If the timer is stopped when reset is selected it will set
the clock to the originally set value and will not begin the countdown until start is selected.
Remote displays
Remote displays can be individually set via the race display to show a single variable.
Confi guring remote display data
Select the remote menu, then select the remote display (e.g. 20/20 HV) you wish to confi gure.
¼ Note: The remote display will fl ash on and off to indicate it has been selected for editing by
the race display.
MENU
x2
Use the UP/DOWN and ENTER keys to navigate to a variable and select the variable to
display. Exit by pressing the PAGE key.
Lighting zone selection
Set the lighting zone on the display. All units in the selected lighting zone will mirror each
others light settings. Default setting is network.
MENU
¼ Note:
Press and hold the MENU / LIGHTS key to get to the Lighting menu.