B&G H5000 Pilot Computer - Manual (Page 30)

30 | Operation | H5000 Operation Manual
Man Over Board
If an emergency situation should occur and a man over board event is triggered, the display
automatically switches to the MOB screen.
7
6
5
4
1
2
3
Displayed data
No. Description No. Description
1 Last known MOB position 5 Direction to MOB from vessel
2 Bearing to MOB 6 Dead reckoned MOB position
3 Range to MOB 7 Last known MOB position
4 Vessel (Always points up)
• A waypoint becomes active at the position the man over board is activated. This is indicated
with a circular symbol. If the man over board event is activated via an AIS-SART then this
position will update via the AIS-SART signal.
• The GPS longitude and latitude co-ordinates of the last known position are shown in the top
left of the screen with the bearing and range MOB waypoint data listed below.
• If you have an H5000 CPU on the network the CPU will perform dead reckoning calculations
to provide the estimated position of the man over board. This position will be displayed as a
triangle symbol.
Vessel
Last known MOB position (H5000 CPU or MFD required)
Dead reckoned MOB position (H5000 CPU required)
¼ Note: To cancel the man over board event press MENU and select cancel.