B&G H5000 Pilot Computer - Manual (Page 32)

32 | Operation | H5000 Operation Manual
Alarms
If you have the relevant sensor connected to the network you can enable that alarm by
selecting it/them from the alarm list.
Alarm on / off
Turn an alarm on or off from the alarm list. A tick symbol next to the alarm in the alarm list will
indicate that the alarm is on.
¼ Note:
It is possible to enable / disable all alarms by selecting the ‘Alarms Enabled’ fi eld from
the Alarms menu.
Alarm settings
1 Press MENU on an alarm that requires parameters to be set will take you to the Enabled / Set limit
menu.
2 Select Set limit
3 Set the required alarm parameter
4 Press the PAGE key once you have fi nished editing
5 Select OK to confi rm.