Carlo Gavazzi PQT-90 - Manual (Page 18)

❑
Communication setup
[1] Choose the mode and connection type (see also
“PQTSoft remote” on page 6). If “Local network of instru-
ments (RS485)” has been selected, then also the network
address of the PQT-90 with which the communication will
take place is to be indicated (see figure above).
[2] Only if “Local single instrument (RS232)” or “Local net-
work of instruments (RS485)” have been selected, the serial
communication port of the PC can also be selected.
❑
End of the configuration
After the configuration of all the
PQT-90 parameters, press the
key “End”. The new configura-
tion will be added to the list of
the configurations archive where
you can select it and transmit it
to the instrument.
❑
Transmit the configuration
[1] Modify the configuration selected in the list.
[2] Delete the configuration selected in the list.
[3] Transmit the configuration selected in the list.
PQTSoft Remote
Transmission of configuration
Application bar: meaning of the icon
35
56
33
PQTSoft Remote
32
Transmission of configuration
Mode and connection type
8
6
1 3 2
1
2