Carlo Gavazzi PQT-90 - Manual (Page 6)

PQTSoft Remote
Configuration
Available modules
29
42
9
■
Main menu
1- Drop-down menu of the functions
2- Programming of PQT-90 and programming start-up
3- Reading of instantaneous variables (page 35)
4- Reset of all the water and gas energy meters (page 36)
5- Automatic configuration of analogue modem (page 36)
6- Automatic configuration of GSM modem (page 36)
7- Contact management (page 37)
8- Programme status.
■
Configuration of PQT-90
❑
Configurations archive and remote PQT programming
PQTSoft Remote
8
Configuration
1 3 4 5 2
2
1
3
PQTSoft Remote manages a configuration archive that may be
selected at any time. At first, when the software has just been
installed, this file is empty. [1] Click on new configuration to start
the programming procedure of PQT90. [2] It allows to load from
PQT-90 the pre-existing programming and to modify it, if
required. [3] Close the window without modifications.
❑
Instrument composition...
[1] Enter the name required for the new configuration of PQT-90.
[2] Select the supplied modules installed in the instrument in
the various slots. For the module AR1041 only, if it is present,
also the operating mode is to be indicated as follows:
“AR1041 module (slave)”: PQT-90 is enabled to the data-
download only on request of the user;
“AR1041 module with analogue or GSM (Master+Slave)”
modem: PQT-90 is enabled to the data download on request
and to the independent transmission of SMS in case of
alarm activation;
“AR1041 module with GSM modem for SMS (Master)”:
PQT-90 is enabled to transmit SMS messages and to send
8 6 7
2
1
3