Carlo Gavazzi PQT-90 - Manual (Page 19)

❑
Network address and warning messages
[1] Selects whether to “carry out the operation on a single instru-
ment” in the (local or remote) network, therefore the address of
the selected instrument [2] will have to be indicated, or to “carry
out the same operation on all the instrument located on the
(local or remote) network”
[3] End the “communication setup” procedure, starting the
transmission of the configuration to the PQT-90.
■ Reading of instantaneous variables
It allows the reading of all the variables in real time divided
into two pages: one dedicated to the instantaneous
variables and one dedicated to the meters.
After clicking the function button on the main menu
bar, set the communication type, as explained from page 33,
then click on the “end” button [3].
❑
Selection of phone numbers and setting of dialling
properties
If in the “Communication setup” dialog box the option
“modem” has been selected, then also the telephone num-
ber to be dialled by PQTSoft for the modem connection with
the instrument will have to be selected.
[1] Click the contact to select it. The phone number of the
contact will be shown in the “number to be dialled” box
below the list.
The window for the selection of the contacts will be shown
only in the case of “modem” selection in the
“Communication setup” dialog box.
[2] For further information on the contact selection and
dialling properties see pages 37 to 39.
PQTSoft Remote
Transmission of configuration
Reading of instantaneous variables 82
35
PQTSoft Remote
34
Transmission of configuration
33
1
2
1
2
3