Carlo Gavazzi PQT-90 - Manual (Page 20)

❑
Selection of connections and setting of dialling properties
This function allows the selection of the list of contacts: create
new contacts, modify them or remove them from the list, simply
clicking on the relevant buttons.
[1] Enter a new contact in the list.
[2] Modify the data of a selected contact.
[3] Delete a selected contact.
[4] Select in detail the dialling properties and decide
whether to use them or not when dialling the telephone
numbers (see dialling properties on the following page).
The defined dialling properties relate to all telephone
numbers present in the list. You can also decide not to
use the above defined dialling properties by not ticking
the relevant check box.
■
Reset of partial and total meters
Reset all the energy, water and gas total and partial meters.
After clicking on the function button on the main menu bar,
set the type of communication, as explained from page 33.
At the following window:
[1] Select if the reset command is to be carried out for all the
instruments located on the network or only on a single
instrument.
[2] Select the network address corresponding to the
required PQT. [3] Carry out the reset.
Steps 1 and 2 are active only for network instruments.
PQTSoft Remote
Last functions
39
37
PQTSoft Remote
36
Last functions
1 2 3
4
■
Automatic modem configuration
It allows the automatic configuration of the analog-
ic/GSM modem for the best communication with
PQT-90. Follow the instructions given in the win-
dow, then verify that the connections between
modem and PC are correct, finally press the “OK” button.
1
2
3