Compex Technologies WPE54 - Manual (Page 20)

Chapter 2 Hardware Installation
19
2.2 Hardware Installation
In three simple steps, you may power ON and begin configuring the access point.
Use the RJ45 cable to connect the Ethernet port of the access point to your PC.
Once you have finished configuring the access point, you can connect the Ethernet
cable to your network device, such as to a switch or hub.
Next, attach the power adapter supplied in the packaging to the main power supply and
connect its power plug into the DC jack of the access point.
Power ON your PC. Notice that the Power and LAN LEDs of the access point have
lighted up. This indicates that the connection has been established successfully
between the AP and your PC.