Compex Technologies WPE54 - Manual (Page 46)

Chapter 4 Common Configuration
45
4.4.1.1 Wireless Pseudo VLAN Per Node
When implemented, this mode isolates each wireless client into its own
pseudo VLAN. Wireless clients can therefore access resources on the wired
network but are unable to see each other or access each other’s data.
The following steps demonstrate how to set up a Wireless Pseudo VLAN per
Node.
Wireless Pseudo VLAN – Per Node
From WLAN Setup under Configuration, click on Advanced, which shows the WLAN
Advanced Setup page.
Go to the Extended Features
section, and click on the
Access
Control button
The Wireless Pseudo VLAN
function is Disabled by default.
Select Per Node from the drop-
down list.
Click on the
Apply button.