Compex Technologies WPE54 - Manual (Page 29)

Chapter 4 Common Configuration
28
This table describes the parameters that can be modified in the Management Port
Setup page.
Parameters Description
IP Address The LAN IP address of the access point is set by default to 192.168.168.1.
When the DHCP server of the AP is enabled (unless you set a different DHCP
Gateway IP Address), this LAN IP Address would also be allocated as the
Default Gateway of the DHCP client.
Network Mask The Network Mask serves to identify the subnet in which the access point resides.
The default network mask is 255.255.255.0.
Management
Gateway IP (Optional) The Management Gateway here acts as the equivalent of the Default
Gateway of a PC, to allow the access point to communicate with devices on
different subnets. For instance, if you want to access the unit from the Internet or
from a router on the LAN, you can set the IP address of the router as the
Management Gateway IP.
The Management Gateway IP address of the access point is set to nil by default.
The next two fields (DHCP Start IP Address and DHCP End IP Address) allow you to define the range
of IP addresses from which the DHCP Server can assign an IP address to the LAN.
DHCP Start IP
Address
This is the first IP address that the DHCP server will assign. The value that you
input here should belong to the same subnet as the access point. For example, if
the IP address and network mask of the access point are 192.168.168.1 and
255.255.255.0 respectively, the DHCP Start IP Address should be 192.168.168.X,
where X can take any value from 2 to 254. It is pre-set to 192.168.168.100.
DHCP End IP
Address This is the last IP address that the DHCP server can assign. It should also
belong to the same subnet as the access point. For instance, if the IP address and
network mask of the access point are 192.168.168.1 and 255.255.255.0
respectively, the DHCP End IP Address should be 192.168.168.X, where X can
take any value from 2 to 254. It is pre-set as 192.168.168.254.
DHCP Gateway IP Though usually, the DHCP server also acts as the Default Gateway of the DHCP
client, the access point gives you the option to define a different DHCP Gateway
IP Address, which will be allocated as the Default Gateway of the DHCP client.
The DHCP client will thus receive its dynamic IP address from the access point
but will access to the Internet or to the other LAN through the Default Gateway
defined by the DHCP Gateway IP Address.
For instance, when the unit is used in Access Point Client mode and connects to
an Internet gateway,
X , a PC wired to the access point will be unable to obtain a
dynamic IP address directly from X . But if you enable the DHCP server of the
access point and set the X as the DHCP Gateway IP Address, the PC will then
obtain its IP address from the access point and access the Internet through X .