Compex Technologies WPE54 - Manual (Page 50)

Chapter 4 Common Configuration
49
4.4.1.3 Tag VLAN
- [Available in Access Point mode ONLY]
While a port-based VLAN is limited in size since it can only exist within the
confines of a single Ethernet switch, a Tag VLAN is designed to extend the
wired VLAN to individual wireless clients.
Here, each VLAN is identified by a ‘tag’, which the switch associates with
specific ports. The switch will then pass this tag information with every data
packet transmitted. By using the same tag on each access point in the network,
full client roaming can be implemented while complying with VLAN
integrity.
Wireless Pseudo VLAN – Tag VLAN
From WLAN Setup under Configuration, click on Advanced, which shows the WLAN
Advanced Setup page.:
Go to the Extended Features section.
Click on the
Access Control button.
The Wireless Pseudo VLAN function
is Disabled by default.
Select Tag VLAN from the drop-down
list.
Click on the
Apply button.
The Tag VLAN page enables you to manage specific VLAN groups by adding or deleting
clients through their MAC address.
Click on the
Add button.