Yamaha LS9 - Manual (Page 189)

189
User Level settings
19
User settings (Secur
ity)
LS9-16/32 Owner’s Manual
3
Move the cursor to the CREATE USER KEY
button and press the [ENTER] key.
The CREATE USER KEY popup window will appear.
1 USER NAME
The user name of up to eight characters is shown (and
can be edited) here. When you move the cursor to this
field and press the [ENTER] key, a keyboard window
will appear, allowing you to enter a user name (
→
p. 34).
B PASSWORD
Specify a password of up to eight characters. Press this
to access a keyboard window where you can enter the
password (
→ p. 34).
C POWER USER
Specifies whether Power User privileges will be
granted to this user.
D Access permission settings
These settings specify the range of operations that the
user can perform. For details on each item, refer to
p.193.
4
When you have specified the user name,
password, power user privileges on/off, and
user rights, move the cursor to the CREATE
button and press the [ENTER] key.
If you are logged-in as the Administrator, the user
authentication key will be saved on USB memory.
If you are logged-in as a Power User, a dialog box will
ask you to confirm the store-destination USB memory.
If you want to save the user authentication key on dif-
ferent USB memory, connect the desired USB mem-
ory and then press [OK].
In order to operate the LS9, you must log in as the Admin-
istrator, Guest, or a User.
User settings for the Administrator and Guest are saved in
the console itself, but in order to log in as a User you must
connect USB memory on which a user authentication key
has been saved. If you disconnect the USB memory after
logging-in, your access privileges will forcibly revert to
Guest.
● Logging-in as Administrator
1
In the DISPLAY ACCESS section, press the
[SETUP] key repeatedly to access the USER
SETUP screen.
2
Move the cursor to the log-in popup button
and press the [ENTER] key.
The LOGIN popup window will appear.
1 2 3
4
Logging-in
• If the power is turned off and then on again, the console will gener-
ally start up in the log-in state in which the power was turned off. If
a user password has been assigned, you will need to enter the
password. However if you cancel the input, you will be forcibly
logged-in as Guest. Similarly, you will also be forcibly logged-in as
Guest if you had been logged-in as a user requiring a user authen-
tication key, but USB memory is no longer connected.
NOTE
Log-in popup button