Yamaha LS9 - Manual (Page 71)

71
Sending signals from MIX channels to the STEREO/MONO bus
6
Output channel oper
ations
LS9-16/32 Owner’s Manual
This section explains how to send the signal of a MIX channel to the STEREO bus or MONO
bus.
Signals can be sent to the STEREO bus or MONO bus in either ST/MONO mode or LCR mode,
and you can choose either of these two modes for each MIX channel. These two modes differ as
follows.
■ ST/MONO mode
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
This mode sends the signal from the MIX channel to the STEREO bus and to the MONO bus independently.
• The signals sent from the same MIX channel to the STEREO bus and to the MONO bus can be switched on/off
individually.
• The panning of the signal sent from a monaural MIX channel to the STEREO bus L/R can be operated by the
SELECTED CHANNEL section [PAN] encoder, or by the TO ST PAN knob in the screen. (The signal sent to
the MONO bus is not affected by this encoder or knob.)
• The volume balance of the signals sent from two stereo-assigned MIX channels to the STEREO bus left and
right can be operated by the SELECTED CHANNEL section [PAN] encoder, or by the TO ST BAL knob in
the screen. (The signal sent to the MONO bus is not affected by this knob.)
■ LCR mode
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
This mode sends the signal of the MIX channel to a total of three buses (STEREO (L/R) and MONO (C)) together.
• The signals sent from the same MIX channel to the STEREO bus and to the MONO bus can be switched on/off
together.
• The CSR (Center Side Ratio) knob in the screen adjusts the proportion of the signal level sent from the MIX
channel to the STEREO (L/R) bus and the level sent to the MONO (C) bus.
• The level of the signal sent from the MIX channel to the STEREO (L/R) bus and the MONO (C) bus will
change according to the settings of the SELECTED CHANNEL section [PAN] encoder or the TO ST PAN
knob / TO ST BAL knob in the screen.
1
Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
1 TO ST field
B TO ST PAN knob (for a stereo MIX channel,
the TO ST BAL knob)
2
In the LAYER section, press the LAYER
[MASTER] key to select the master fader
layer.
3
Press a [SEL] key in the channel module
section to select the send-source MIX chan-
nel.
4
If you only want to adjust the pan or bal-
ance of the MIX channel, operate the
SELECTED CHANNEL section [PAN]
encoder (
→ p. 86).
You can obtain the same result by moving the cursor to
the PAN/BAL knob in the SELECTED CH VIEW
screen and operating the dial or the [DEC]/[INC] keys.
Sending signals from MIX channels to the STEREO/MONO bus
• If you want to use headphones etc. to monitor the signal of the STEREO bus or MONO bus, you should
press the DISPLAY ACCESS section [MONITOR] key several times to access the MONITOR (2/4) screen,
and select “LCR” as the monitor source (
→ p. 146) before you continue with the following procedure.
HINT
1 2