Canon BJ-200ex - Manual (Page 107)

Graphics character set, which is the same as the MS-DOS code page 437 (this
character set includes sysmbols, lines, corners, and European characters).
To see samples of the character sets available in Epson LQ mode, use Canon's
toll-free fax retrieval system. Call the Canon help desk and request the fax
retrieval system; then request the
BJ-200ex Printer Command Summary.
DIP switches 5, 6, 7 DIP switches 5, 6, 7
These switches allow you to select one of eight international character sets. These
character sets provide you with the characters and sy\mbols used in other
languages.
DIP switches
Character set 5 6 7
USA OFF OFF OFF
United Kingdom OFF OFF ON
Germany OFF ON OFF
France OFF ON ON
Denmark ON OFF OFF
Sweden ON OFF ON
Italy ON ON OFF
Spain ON ON ON
DIP switches 8, 9, 10 DIP switches 8, 9, 10
These switches allow you to select one of eight font typefaces.
DIP switches
Typeface 8 9 10
Roman
OFF
ON
ON OFF
ON
ON OFF
OFF
ON
Sans serif OFF OFF ON
Draft OFF ON OFF
Courier OFF ON ON
Prestige ON OFF OFF
Script ON OFF ON
Orator ON ON OFF
Orator-S ON ON ON
DIP switch 11 DIP switch 11
When this switch is OFF, the printer is in BJ-10 mode. When this switch is ON,
the printer is in Epson LQ mode.
DIP switch 12 DIP switch 12
This switch enables or disables automatic emulations switching mode. (See page
129 for a description.)
Changing a DIP Switch Setting
The DIP switches are located to the left of the operator panel under a small cover.
A DIP switch is OFF when it is up, and ON when it is down. To change a DIP
switch setting, follow these steps:
1. Make sure the printer is turned off.
§ The POWER light should be off.
§ If the power is on now, press the POWER button to turn off the
printer.
2. Open the DIP switch cover on the top of the printer.