Canon BJ-200ex - Manual (Page 74)

Script Not available
10 cpi, 12cpi, 15 cpi,
17 cpi, 20 cpi, PS
Orator Not available
10 cpi, 12cpi, 15 cpi,
17 cpi, 20 cpi, PS
Orator-S Not available
10 cpi, 12cpi, 15 cpi,
17 cpi, 20 cpi, PS
* In Epson LQ mode, if you select Sans Serif, the printer
uses the Gothic font.
The following table lists the print styles that are available in
each printer control mode.
Printer control mode
Print style BJ mode Epson LQ mode
Italic No Yes
Emphasized Yes (via ESC E sequence) Yes (via ESC E sequence)
Double-high Yes (via ESC [ @ sequence) Yes (via ESC w sequence)
Double-wide Yes (via ESC W sequence) Yes (via ESC W sequence)
Slashed zero Yes (via ESC [ K sequence) No
To select the printer control mode, use DIP switch 11.
Refer to Chapter 8, Customizing the Printer, for
information on DIP switches.
Setting Up WordPerfect for Your Printer
This section contains the procedures you perform to install
the Bubble Jet Printer BJ-200ex driver for WordPerfect,
version 5.1 or 6.0, for MS-DOS. These instructions assume
you have installed WordPerfect and are familiar with using
it.
1. Make sure your computer is turned on.
2. Make a backup copy of the diskette containing the Canon BJ-
200ex printer drivers for WordPerfect (if you have not already
done so). This is disk 2 of the Windows Driver and Visual
Guide.
3. At the MS-DOS prompt, copy the WordPerfect driver, either
51BJ2E.ALL or 60BJ2E.ALL, to your WordPerfect directory.
For example, if you are using WordPerfect 5.1 and your
directory is WP51, you insert the diskette with the drivers into
drive A and type this command:
COPY A:WP51BJ2E.ALL C:\WP51
If you are using WordPerfect 6.0 and your
directory is wp60, insert the driver diskette
into Drive A and type:
COPY A:QP60BJ2E.ALL C:\WP60
4. Change to the WordPerfect directory and start WordPerfect by
typing WP and pressing Enter.
5. At the document screen, press Shift + F7.