Canon BJ-200ex - Manual (Page 59)

To start the Demo Prints, follow these steps:
1. Press the POWER button to turn off the printer.
2. To start Demo Print 1: press and hold the ON LINE
button, and press the POWER button until the beeper
sounds twice.
§ The two beeps are approximately three
seconds apart.
§ The printer starts to print Demo Print 1.
3. To start Demo Print 2: press and hold the ON LINE
button, and press the POWER button until the beeper
sounds three times.
§ The first two beeps are approximately three
seconds apart. The next beep is one second
later.
§ The printer starts to print the Demo Print 2.
Stopping
To stop printing the Demo Print, press and hold the ON
LINE button for one second. The printer stops printing,
ejects the current sheet of paper, and goes back on-line.
Demo print 1 looks like this:
Demo Print 2 is similar to Demo Print 1 but shows the
advantages of Smoothing mode. In Smoothing mode, the
jagged edges and ragged stair-stepping curves of characters
and graphics are polished and refined.
Pausing a Print Operation
When the ON LINE light is on, the printer is on-line and
ready to receive data from your computer. At this time, you
can send print data from your computer to the printer.
While you are printing a document, you may want to pause
the printer.
Follow these steps:
1. To pause printing while the printer is working, press the
ON LINE button.