Compaq MP1800 - Manual (Page 12)

1-6 Getting Started
Part Number: 191443-001 - Writer: JGilbert - Saved by: J Abercrombie
Pages: 18 Words: 2604 Saved date: 05/17/004:43 PM File Name: Ch01
Connecting the Projector to a Portable Computer
1. Rotate the elevator foot to balance the projector.
2. Connect one end of the projector signal cable to the projector
and the other end to the VGA connector
➊B or the DFP
connector
➊A on the portable computer and tighten the screws.
✎ Be sure the signal cable aligns with the connector.
Do not force the cable onto the connector or you
may damage the signal cable or the projector.
3. Connect one end of the power cord
➋ into the back of the
projector, and the other end to an electrical outlet that is easily
accessible and close to the projector.
4. Turn on the projector first, then turn on the computer. Refer to
the “Powering On the Projector” section later in this chapter for
instructions on turning on the projector.
✎ For security purposes, this projector has been fitted
with a security lock slot
➌ (located on the left, front
side) for use with a security cable lock that can be
purchased separately at most computer stores.