Power cords – Compaq MP1800 User Manual
Page 66
B-6 Agency Regulatory Notices
Part Number: 191443-001 - Writer: David Calvert - Saved by: EPerlman
Pages: 6 Words: 1132 File Name: Agency Regulatory Notices Saved date: 05/17/00 4:44 PM
Power Cords
The projector power supply is provided with Automatic Line
Switching (ALS). This feature allows the projector to operate
on input voltages between 100-120V or 200-240V.
The power cord set (flexible cord or wall plug) received with
the projector meets the requirements for use in the country
where you purchased the equipment.
If you need to obtain a power cord for a different country,
you should purchase a power cord that is approved for use in
that country.
The power cord must be rated for the product and for the
voltage and current marked on the product’s electrical ratings
label. The voltage and current rating of the cord should be
greater than the voltage and current rating marked on the
product. In addition, the diameter of the wire must be a
minimum of 0.75 mm
2
or 18AWG, and the length of the cord
must be between 6 feet (1.8 m) and 12 feet (3.6 m). If you
have questions about the type of power cord to use, contact
your Compaq authorized service provider.
A power cord should be routed so that it is not likely to be
walked on or pinched by items placed upon it or against it.
Particular attention should be paid to the plug, electrical
outlet, and the point where the cord exits from the product.