Vertical Communications 8324S - Manual (Page 116)

10.6 Naming The Telephone Lines
You can assign names to lines to aid users in identifying the proper line
to use. A line name can be up to seven letters in length and will show up
in the user’s display.
•
Name the system telephones as follows:
1. Use letter code table (page 10–13) to compose names for all lines
requiring them (up to seven letters per name are allowed) and
record the names on the line name record (page 10–14).
2. Press INTERCOM.
3. Dial ✳ # 0 ✳3 3.
4. Dial code to choose line:
• dial 1#–99# for lines 1–99,
• dial 100–128 for lines 100–128.
NOTE: If the desired line code is less than three digits, you must dial #
once after you dial the line code. For example, dial 1# for line
1 or 19# for line 19.
5. Dial # to clear any current name.
6. Dial two-digit codes that correspond to letters in name
(line names must begin with a letter).
7. Dial # to save name or cleared name.
8. Dial next line number (plus # if less than three digits), dial # to
clear current entry, dial codes for letters, dial # to save.
9. Repeat previous step until all telephones are named.
10. Press SPEAKER to end.
Using The Attendant Features GCA70–250
10 – 12 LCD Speakerphone Reference Manual