Sony DCR-PC10 - Manual (Page 100)

Trouble check I
Others
Symptom Cause and/or corrective actions
While editing using the DV connecting
cable, recording picture cannot be
monitored. • Remove the DV connecting cable, and connect it
again.
The camcorder becomes warm. • If the power of the cammcorder is on for a long time,
it becomes warm, which is not malfunction.
The supplied Remote Commander does • COMMANDER is set to OFF in the'menu system.
not work.
•
Set it to ON. (p. 34)
Something is blocking the infrared rays.
■> Remove the obstacle.
• The battery is not inserted with the correct polarity.
*> Insert the battery with the correct polarity, (p. 118)
• The batteries are dead.
Insert new ones. (p. 118)
The ВАТТ CHARGE lamp flashes after
you charge the battery pack installed in
the camcorder. • The camcorder is not malfunctioning.
No function works though the power is • Disconnect the connection plug on the battery pack or
on. on the AC power adaptor, then reconnect it after
about 1 minute. Turn the power on. If the functions
still do not work, press the RESET button at the lower
right from the START/STOP MODE switch using a
sharp-pointed object. (If you press the RESET button,
all the settings including the date and time return to
the default.) (p. 116)
AC power adaptor
Symptom Corrective actions
The VTR/CAMERA or CHARGE lamp * Disconnect the power cord. After about 1 minute,
does not light. reconnect the power cord. (p. 8)
The CHARGE lamp flashes. • See the chart on the next page.
102