Prepare the remote commander – Sony KV-27XBR55 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1
3. Prepare the Remote Commander
Install the batteries in the Programmable
Remote Commander
Install the batteries in the Mini Remote
1
Push to open the lid.
\ Install two size AA (R6) batteries with the correct polarity.
I Replace the lid.
• Under normal operation, batteries will last up to half a year.
If the Remote Commander does not operate properly, the
batteries might be œchausted. Replace both of them with
new ones.
• To avoid damage from possible battery leakage, remove the
batteries if you will not use the Remote Commander for a
longtime.
(The Mini Remote is supplied to KV-27XBRS1,32XBR51,
27XBRSSand32XBRSS, only.)
1
Insert a thin instrument into the hole, and while pressing
it in the direction of the arrow (0), pull out the battery
case((|)).
I insert a Sony CR2025 battery with the flat surface
' (positive side) upward.
Caution
On the lithium battery
• Keep the iithium batt^ out of the reach of chikiren.
Shouid the battery be swaiiowed, immediateiy consult a doctor.
• Be sure to observe the correct polarity when installing the battery.
• Oo not hold the battery with metallic tweezers, otherwise a short*
circuit may occur.
• Replace the battery with a Sony CR2025 lithium battery.
Use of another battery may present a risk of fire or explosion.
WARNING
Battery may explode if mistreated. Do not recharge,
disassemble or dispose of it in fire.
■f I Chapter 1: Set up