Sony KV-27XBR55 - Manual (Page 60)

vt <mot wmt wotot
C3aaa
o®® B
00 ® fil
D © 0 S a
SUV (WOMTl JWF
aiQcnacj
nm * * "WWg ot t)w>
gjgjqQg
CNtWK
f^mm I I So
0-9, ENTER
■CODE SET
■VCR operating
area
*?A*fnH VTR1-2-3MDP
selector
CABLE VIDEO
selector
l^ote
Operating Non-Sony or Sony Video Equipment
(Pre-programmed Function)
The supplied Remote Ckjmmander has pre-programmed functions.
Vws you can operate non-Sony video equ^ment with Ore supplied Remote
Commander by setting the manufacturer’s code.
Setting the manufacturer’e code
1 Set the CABLE/VIDEO selector to VIDEO.
CABLE VIDEO
ÙÎ
Set the VTR1^!^/M0P selector to the position that you want to operate the
equipment at.
By employing the VTR1/2/3 settings, you can use your re­
mote commander to operate up to 3 pieces of equipment.
Note: If you also use Sony video equipment, set other
maker’s equipment to a position not being used for your Sony
video equipment.
vn^3 jgP
While pressing CODE SET, press manufacture’s code numbers (See table).
O0©
000
000
Press ENTER.
The LEARN indicator turns green and then goes off. (A long beep)
Now you can operate the non-Sony video equipment with the
supplied Remote Commander.
Use the video operating buttons to operate video equipment.
ENTER
Vbu may not be able to operate your non-Sony
video equipment with the supplied Remote
Commander. This is because your equipment
may use a code that is not provided with this
Remote Commander. In this case, please use
the remote control unit provided with the non-
Sony equipment.
60 Chapter 4; Advanced Operation