Sony KV-27XBR55 - Manual (Page 18)

5 l If Ybu Want to Connect Other Equipment
VCRsArideo disc players not equipped with an S video output Jack
: Signal flow Rear of TV
VCR, Videodisc
piayer.etc.
to
audioMdeo
output
VM0810S/820S
(not supplied)
VMCS10S/820S-
(notsuppiied)
to audio/
video input
VCR
Preparations
1
UimontheTV.
2
Press the TV/VIDEO button on the TV or an input
select button on the Remote Commander so that the
“VIDEO’1’,“VIDE02”or“VIDE03”indication appears
on the screen.
VIDE01 : for equipment connected to VIDE011N
VIDEO 2: for equipment connected to VIDEO 2 IN
VIDEO 3: for equipment connected to VIDEO 3 IN
•
• You can label each of these input modes. For details,
see page 4&
• You need not to select mode when you use the direct
play function. For details, see page 50.
Operation
For operation, refer to the instruction manual furnished with
the VCR.
When you use an infrared remote control VCR, you can
operate the VCR with the supplied Remote Commander
regardless of it is Sony VCR or non-Sony VCR.
See "Using the Programmable Remote Commander" on
page 61.
To return to the TV mode
— Press the TV/VIDEO button on the TV so that a channel
number appears on the screen.
— Press the TV button on the Remote Commander.
To view one TV program while recording another
Press the TV/VTR mode select button on the VCR or Remote Com­
mander so that the VCR will be in the TV mode. Press the TV button
on the Remote Commander, and select the channel you want to view.
When you cannot obtain a clear picture and/or sound
Make sure that the TV/VTR nnode select button on the VCR is set to
TV. Re-select the desired channel with the buttons on the TV or the
Remote Commander.
18 Chapter 1: Set up