Setting tone or pulse dialing type, Other advanced features for sending faxes – Sony IJP-V100 User Manual
Page 60
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing the information printed at the top
of the faxes you send
When you first installed the Sony UP-V100 software, you were asked
to enter your name and fax number. This information was stored for
use in the header that’s printed at the top of all of your outgoing faxes.
Notes:
1) Only the fax recipient will see this information upon receipt of
your fax; it’s not printed on your original document.
2) The Telephone Consumer Protection Act of 1991 requires that, in
the U.S., all outgoing faxes display the sender’s identifying name and
fax number in a header, footer, or on the cover page of the outgoing
fax.
Use the following procedure to change the fax header information.
O
Double-click
VAIO Document Space
on your Windows desk
top.
o Click
Fax
and select
Send Settings.
o Click the
Personal Information
tab and change the information
in the two entry boxes in the Fax Header Content area.
Setting Tone or Pulse dialing type
The Sony IJP-VlOO is factory-set for tone dialing. Nearly all phones
being used in the U.S. have tone dialing.
Note: Don’t change this setting unless you know your phone isn’t
capable of tone dialing. Pulse dialing is much slower than tone
dialing.
O
Double-click
VAIO Document Space
on your Windows desk
top.
o Click
Fax
and select
Send Settings.
o Click the
Dialing
tab and select
Tone Dial
or
Pulse Dial
in the
Phone Dialing Type area.
Other advanced features for sending faxes
There are many advanced features available in the Sony IJP-VlOO
software. The best way to learn about these features is to explore
them in the dialog boxes referenced in the following table, and click