AVer SEB3104H - Manual (Page 45)

39
6. To store the setting, click Save.
7. To end Schedule Setting, click OK to exit and accept the setting and Cancel to exit.
3.4.2 Setup Recording Schedule
To setup recording schedule based on date, time, and record modes.
i
Recording schedule must be set in order to record.
To Set the Recording Schedule:
1. Click
> Schedule > Record tab.
2. Select the camera or mark Select All to select all cameras.
3. Select the record mode. Click  to make a selection.
- Always Record
Record the video from the selected camera and save it to the designated storage path.
- Motion Record
Start recording the video from the selected camera only when the system detects movement.
Once a motion is detected, the system automatically saves the previous frames and stop
based on the Pre Record Time and After Record Time settings.
- Sensor Record
Start recording the video from the selected camera only when the sensor has been triggered.
Once a sensor is triggered, the system automatically saves the previous frames and stop
based on the Pre Record Time and After Record Time settings.
- Smart Record
Automatically switch to recorded at the maximum frame rate setting once a motion is
detected and if there is no motion, it records at the minimum frame rate setting. Set the
maximum frame rate setting in
Chapter 3.3 Recording Setup .
- None
The system won’t do any recording.
4. After select the record mode, click the specific schedule block or click All to select all. To
un-select the specific schedule blocks, select None and click blocks to un-select. Click Clear will