AVer SEB3104H - Manual (Page 49)

43
4. Select Trigger Any to activate if it falls to one of the conditions or Trigger All to activate if it falls
to all conditions.
5. Set condition of Camera.
- Motion: click on the camera number (01 to 04) to set the condition for the system to alarm.
- In Video Loss, click the camera number (01 to 04) to set the alarm condition when video is
lost.
6. Set condition of Sensor. Click on the sensor number to set the condition for the system to alarm.
If the sensor normal status is high, set the sensor condition to low.
7. Set condition of Alarm reset. Click the camera number to set the reset condition of alarm. Once
alarm is reset, all alarm action will stop at the moment.
8. Click Next to setup actions of alarm.
- Enlarge Camera View
Switch to only display video in preview mode from where the alarm is activated.
a. Select the camera from drop down list to specify which camera video to be enlarged on
screen when the alarm is triggered.
 Alarm Camera: when a channel has an alarm occurred, and then, the channel video
that has an alarm occurred will be enlarged on screen.
 Camera # (1~4): the selected channel video that will be enlarged on screen when an
alarm is activated.
b. Retrieve time: set the waiting duration before system switching back to original Preview
mode. If the retrieve time is un-mark, the alarm video will keep enlarging until user switch
back to Preview mode manually.