Kontron AT8060 - Manual (Page 104)

Software Setup
89 AT8060
www.kontron.com
Flow Control
None, Hardware
RTS/CTS
Flow control can prevent
data loss from buffer
overflow. When sending
data, if the receiving
buffers are full, a 'stop'
signal can be sent to
stop the data flow. Once
the buffers are empty, a
'start' signal can be sent
to re-start the flow.
Hardware flow control
uses two wires to send
start/stop signals.
VT-UTF8 Combo Key
Support
Disabled, Enabled
Enable VT-UTF8
Combination Key
Support for ANSI/VT100
terminals
Recorder Mode Disabled, Enabled
On this mode enabled
only text will be send.
This is to capture
Terminal data.
Resolution 100x31 Disabled, Enabled
Enables or disables
extended terminal
resolution
Legacy OS Redirection
Resolution
80x24, 80x25
On Legacy OS, the
Number of Rows and
Columns supported
redirection
Putty KeyPad
VT100, LINUX,
XTERMR6, SCO,
ESCN, VT400
Select FunctionKey and
KeyPad on Putty.
Force System Vga to Text
Mode
Disabled, Enabled
Enable to Install Linux in
text mode When System
has Vga.
Install Legacy OS through
Remote
Disabled, Enabled
Enable to Install Legacy
OS like Linux in text/
graphics mode through
redirection When System
has Vga. This might not
work for all Linux
Versions.
Redirection After BIOS
POST
Always Enable,
BootLoader
The Settings specify if
BootLoader is selected
than Legacy console
redirection is disabled
before booting to Legacy
OS. Default value is
Always Enable which
means Legaacy console
Redirection is enabled
for Legacy OS.
Feature Option Description Help text