Kontron AT8060 - Manual (Page 37)

22 AT8060
www.kontron.com
throttle the memory interface in case of overheating. Memory can perform double refresh rate to get higher
maximum operating temperature.
Kontron recommends the use of validated memory with this product. Thermal issues or other problems may
arise if you don’t use recommended modules. At the time of publication of this user guide, the following
memories memory list has been have been qualified and approved. As the memory market is volatile, this list
is subject to change, please consult your local technical support for an up to date list.
3.3.1 Memory List and Characteristics
Table 3-2:Approved Memory List
Memory should have the following characteristics:
• DDR3 1333 or DDR3 1600
• 1.35V or 1,5V
• Single or dual-rank modules are supported
• x4 or x8 memory with up to 4 ranks per DIMM
• Registered & ECC
• Only very low profiles (VLP) 0.72inches maximum heights (18.3mm)
Manufacturer Part Number Description Company
M392B5273CH0-CK0 4GB VLP 1600 MHz RDIMM Samsung
M392B1K70CM0-CK0 8GB VLP 1600 MHz RDIMM Samsung
M392B5273CH0-YH904 8GB VLP 1333 MHz LV-RDIMM Samsung
VL33B5263E-K9S 4GB VLP 1333 MHz UDIMM Virtium
M392B2G70BM0-YK0 16GB VLP 1600 MHz RDIMM Samsung
SGU04G72H1BC2SA-BBRT 4GB VLP 1333 MHz UDIMM Swissbit
MT18JDF1G72PDZ-1G6 8GB VLP 1600 MHz RDIMM Micron
WARNING
Because static electricity can cause damage to electronic devices, take the following
precautions:
Keep the board in its anti-static package, until you are ready to install memory.
Wear a grounding wrist strap before removing the board from its package; this will
discharge any static electricity that may have built up in your body.
Handle the board by the faceplate or its edges.