Rice Lake Intrinsically Safe - Manual (Page 33)

320IS Installation Manual - Configuration 27
STREAM OFF
EDP
PRN Selects the serial port used for continuous transmission. See Section 7.3 on page 48 for
information about the
320IS continuous data format.
PRNDES EDP
PRN Print destination. Selects the port for data transmission when the PRINT key is pressed or the
KPRINT EDP command is sent.
Level 3 Submenus
EDP/Printer Ports
BAUD 9600
19200
38400
300
600
1200
2400
4800 Baud rate. Selects the transmission speed for the EDP or printer port.
BITS 8NONE
7EVEN
7ODD Selects the number of data bits and parity of data transmitted from the EDP or printer port.
TERMIN CR/LF
CR Termination character. Selects the termination character for data sent from the EDP or printer
port.
EOLDLY 000
255 End-of-line delay. Sets the delay period, in 0.1 second intervals, from when a formatted line is
terminated to the beginning of the next formatted serial output. Value specified must be in the
range 000-255, in tenths of a second. Example: 10 = 1 second.
ADDRES 000
number Specifies the decimal indicator address for RS-485 connections. RS-232 communications is
disabled if an address other than zero is specified for this parameter.
PORT RS232
RS422
RS485
CRLOOP
NONE Selects the physical interface for the EDP or printer port.
ECHO ON
OFF Enables or disables echoing of the serial commands sent to the indicator.
SERIAL Menu
Parameter Choices Description
Table 3-5. Serial Menu Parameters (Continued)