Rice Lake Intrinsically Safe - Manual (Page 46)

40 320IS Installation Manual
PWRUPMD Power up mode GO, DELAY
SAMPSIZ Sample size 5, 10, 20, 50, 100, PCWGT
CNTMOD Count mode access DISABLE, ENABLE
UID Unit identifier 000000–999999
STNDBY Standby 0-255
DATEFMT Date format MMDDYY, DDMMYY, YYMMDD, YYDDMM
DATESEP Date Separator SLASH, DASH, SEMI
TIMEFMT Time format 12HOUR, 24HOUR
TIMESEP Time separator COLON, COMMA
Command Description Values
GFMT Gross demand print format string See Section 6.0 on page 43 for detailed information
NFMT Net demand print format string
CFMT Count demand print format
Table 5-8. PFORMT EDP Commands
Command Description Values
DIGIN1
DIGIN2
DIGIN3
DIGIN4 Digital input function OFF, ZERO, TARE, NT/GRS, UNITS, DSPTAR, PRINT, CLRCN,
KBDLOC, HOLD, CLRTAR, CLRACC, ACCUM, ENTER, GROSS,
NET, PRIM, SEC, NEWID
Table 5-9. DIG IN EDP Commands
EDP digital output commands only function in TEST mode (see Figure 7-4 on page 55).
Command Description
DON#n Set digital output n on
DOFF#n Set digital output n off
DOFF#0 Set all digital outputs off
DON#0 Set all digital outputs on
For commands ending with “#n”, n is the digital output (1–4) being set on or off.
Table 5-10. DIG OUT EDP Commands
Command Description Values
AO1.SOURCE Analog output source GROSS, NET
AO1.OFFSET Zero offset 0%, 20%
AO1.ERRACT Error action FULLSC, HOLD, ZEROSC
AO1.MIN Minimum value tracked 0–999 990
AO1.MAX Maximum value tracked 0–999 990
AO1.TWZERO Zero calibration 0–65535
AO1.TWSPAN Span calibration 0–65535
Table 5-11. ALGOUT 1 EDP Commands
Command Description Values
Table 5-7. PROGRM EDP Commands (Continued)