Rice Lake Intrinsically Safe - Manual (Page 45)

320IS Installation Manual - EDP Commands 39
Command Description Values
PRI.DECPNT Primary units decimal position 8.88888, 88.8888, 888.888, 8888.88, 88888.8, 888888, 888880,
888800
PRI.DSPDIV Primary units display divisions 1D, 2D, 5D
PRI.UNITS Primary units LB, KG, OZ, TN, T, G, NONE
SEC.UNITS Secondary units LB, KG, OZ, TN, T, G, NONE
SEC.MULT Secondary units multiplier 0.00000–9999.99
DSPRATE Display rate 250MS, 500MS, 750MS, 1SEC, 1500SEC, 2SEC, 2500MS, 3SEC,
4SEC, 6SEC, 8SEC
Table 5-4. FORMAT EDP Commands
Command Description Values
WZERO Zero calibration -999999 – 999999
WVAL Test weight value 0 – 999999
WSPAN Span calibration -999999 – 999999
REZERO Rezero -999999 – 999999
LC.CD Set deadload coefficient ±268435455
LC.CW Set span coefficient ±268435455
Table 5-5. CALIBR EDP Commands
Command Description Values
EDP.BAUD EDP port baud rate 300, 600, 1200, 2400, 4800, 9600, 19200, 38400
EDP.BITS EDP port data bits/parity 8NONE, 7EVEN, 7ODD
EDP.TERMIN EDP port termination character CR/LF, CR
EDP.EOLDLY EDP port end-of-line delay 0–255 (0.1-second intervals)
EDP.ADDRESS EDP port address 0-255
EDP.PORT EDP port selection RS232, RS422, RS485, CRLOOP, NONE
EDP.ECHO EDP port echo ON, OFF
PRN.BAUD Printer port baud rate 300, 600, 1200, 2400, 4800, 9600, 19200, 38400
PRN.BITS Printer port data bits/parity 8NONE, 7EVEN, 7ODD
PRN.TERMIN Printer port termination character CR/LF, CR
PRN.EOLDLY Printer port end-of-line delay 0–255 (0.1-second intervals)
PRN.ADDRESS Printer port address 0-255
PRN.PORT Printer port selection RS232, RS422, RS485, CRLOOP, NONE
PRN.ECHO Printer port echo ON,OFF
STREAM Streaming port OFF, EDP, PRN
PRNDEST Print destination EDP, PRN
Table 5-6. SERIAL EDP Commands
Command Description Values
REGULAT Regulatory compliance NTEP, OIML, CANADA, NONE
CONSNUM Consecutive number 0–999 999
CONSTUP Consecutive number start-up value 0–999 999
Table 5-7. PROGRM EDP Commands