Rice Lake Intrinsically Safe - Manual (Page 35)

320IS Installation Manual - Configuration 29
UID 000000
number Specifies a unit identifier for the indicator in the range of 000000–999999. The unit ID can be
added to print ticket formats to identify the indicator used to generate ticket formats.
ACCUM OFF
On Accumulator. Specifies whether the accumulator is enabled. if enabled, accumulation occurs
whenever a print operation is performed.
DATE DATFMT
DATSEP Allows selection of date format and date separator. See level three parameter for descriptions.
TIME TIMFMT
TIMSEP Allows selection of time format and time separator. See level three parameter for descriptions.
STNDBY 000
0-255 Standby mode delay. Specifies the number of minutes the indicator must be inactive before
entering standby mode. Valid values are 000 (off) or 0-255 minutes. After typing a standby time
value, press the TARE key to enter this value. The display will go into standby mode, confirmed
by a blinking LED on the right side of the display. When in standby mode, power is still supplied
to the CPU and draws 1/2 of the current as when the display is powered. Press any key to exit
standby mode and reactivate the display.
The indicator enters standby mode if no key presses, serial communications, or scale motion
occur for the length of time specified on this parameter. Set this parameter to 000 to disable
standby mode.
Level 3 submenus
ACCESS DSABLE
ENABLE Operator access to piece count mode. Specify DSABLE if piece count mode will not be used.
With access disabled, pressing the GROSS/NET (MODE) key toggles between gross and net
modes only.
SPLSIZ 10
20
50
100
PCWGT
5 Sample size. Specify the default size used for counting scale operations. Sample size can be
changed in counting mode during sample acquisition.
DATFMT MMDDYY
DDMMYY
YYMMDD Specifies the format used to display or print the date.
DATSEP SLASH
DASH
SEMI Specifies the date separator character.
TIMFMT 24HOUR
12HOUR Specifies the format used to display or print the time.
TIMSEP COLON
COMMA Specifies the time separator character.
PROGRM Menu
Parameter Choices Description
Table 3-6. Program Menu Parameters (Continued)