Rice Lake Upper Body Single Frequency Composition Analyzer - D1000-2 - Manual (Page 15)

Competitor Series Installation & Operation Manual — Installation and Setup 11
3.2 Scale Base Assembly
3.2.1 Leveling The Scale Base
Ensure the scale is placed on a flat, level surface. Thin carpeting is acceptable but a hard surface works best. Turn
the feet in or out until the scale level bubble is centered in the middle of the circle.
Figure 3-1. Center Leveling Bubble
3.3 Digital Display
Place the digital display on a table or other sturdy surface.
If connecting the digital display to the optional column, see Section 3.8 on page 13 to view assembly instructions.
3.4 Power Supply Connections
Refer to Figure 3-2 to connect the power supply to the Competitor Series scale.
Figure 3-2. Competitor Series Component Parts
Connect the 12V AC adapter to the adapter port placed on the rear panel of the digital display. After the cable is
connected press the
ON/OFF
button on the keypad.
12V AC Adapter
Location
DB-9 Connector to
connect display to
scale base
Figure 3-3. Digital Display Connections on the Back