Rice Lake GX Series, A&D Weighing - Manual (Page 12)

10
harm the balance. For accurate weighing, warm up the balance for at least 30 minutes before use.
3-5 Display Symbols and Key Operation
Key operation
Key operation affects how the balance functions. The basic key operations are:
“Press and release the key immediately” or “Press the key”
= normal key operation during measurement
“Press and hold the key”
Display symbols
Each key, when pressed or when pressed and held, functions as follows:
Key When pressed When pressed and held
Turns the display on and off. The standby indicator is displayed when the display is
turned off. The weighing mode is enabled when the display is turned on.
This key is available anytime. Pressing the key during operation will interrupt the
operation and turn the display off.
In the weighing mode, turns the minimum
weighing value on and off.
In the counting or percent mode, enters
the sample storing mode.
Enters the function table mode. Refer to
“9. FUNCTION TABLE”.
Switches the weighing units stored in the
function table. Refer to “4. WEIGHING
UNITS”. Performs response adjustment and self
check.
Performs calibration of the balance using
the internal mass. Displays other items of the calibration
menu.
Stores the weighing data in memory or
outputs to a printer or personal computer
using the RS-232C interface (Factory
setting), depending on the function table No function at the factory setting
By changing the function table:
Outputs “Title block” and “End block” for