Rice Lake TradeRoute HL Series - Low Profile Installation and Setup for Models from 2011 and Older 128406 - Manual (Page 11)

8
Figure 4 – Double / Tandem Positioning
9. Attachment of Scale to Truck
Position the scale modules on the truck frame as per the previous section. Mark the
location of the bolt holes to be drilled through the truck frame, and move the scale
away. Drill 7/8” holes through the channel of the truck frame. Reposition the scale
aligning the holes. Insert shims (flat washers) between the truck frame and the scale
(equal amount on both sides). Bolt the scale to the truck frame using the ¾”x2½” grade
8 bolts, ¾” nuts, and ¾” lock washers supplied. Torque the ¾” bolts to between 90-
110 ft.-lbs.
Figure 5 - Attachment of Scale to Truck Frame