Rice Lake TradeRoute HL Series - Low Profile Installation and Setup for Models from 2011 and Older 128406 - Manual (Page 37)

34
5. Repeat step 3 and 4 if necessary.
6. If temporary racks were used to load the scale, remove the racks and dead load the
scale once more.
7. The scale is now calibrated. Exit the calibration mode by entering:
16.3 Legal for Trade Inspection
The exact inspection procedures may vary slightly from those described below in your
region. The following is the basic inspection procedure:
1. Balance test (as described on page 16).
2. Increasing/Decreasing load test.
3. Out-of-Level Increasing/Decreasing load test.
4. Twist Condition Increasing/Decreasing load test.
5. Out-of-Level shut off test.
6. Printing of Ticket.