Rice Lake TradeRoute HL Series - Low Profile Installation and Setup for Models from 2011 and Older 128406 User Manual
Page 27
Advertising
24
Figure 16 – Setpoint Relay Implementation Schematic
15.8 Load Cell Numbering
Systems balanced at the factory:
Systems that are balanced at the factory have load cell numbers already assigned.
Connect numbered load cell wires to the corresponding connector on the circuit board.
Systems balanced at installation:
Systems that have not been balanced at the factory, but are to be balanced at
installation, should follow the load cell number convention shown below (see Figure 17
and Figure 18).
Advertising