Rice Lake TradeRoute HL Series - Low Profile Installation and Setup for Models from 2011 and Older 128406 - Manual (Page 13)

10
11. Control Box Mounting
A suitable location must be found for the On-Board control box. Rice Lake Weighing
Systems recommends mounting the control box near the front driver’s side corner of
the container. However, the location for the control box is application specific and is
dependent on the end user’s needs. The use of a Compact control box allows for the
indicator to be mounted in the cab which may be preferred.
IMPORTANT: The control box must be mounted level with the scale. The
control box contains a level switch that detects the degree to which the scale is off
level. Therefore, the control box must be mounted level with respect to the scale. On a
compact control box the PCB inside the box must be adjusted to level or a remote level
sensor used.
11.1 700 Series Standard Control Box
The 700 series control box comes standard with vibration mounts to protect the
indicator. A bracket (plate with holes) is required. Ensure the bracket is attached level
with the scale (see above).
IMPORTANT: The red light on the side of the control box must be viewable through
the driver’s rear view mirror.
NOTE: Control box mounting brackets are available from Rice Lake Weighing Systems.