Welch Allyn Connectivity Server - User Manual - Manual (Page 80)

76 Troubleshooting Welch Allyn Connectivity Server
To establish the server IP address
1. In the Server IP Address page, take one of these steps:
• If the listed IP address is the correct address for the hospital side of the WACS
server, tap Test.
• If the listed IP address is an incorrect address for the hospital side of the server,
enter the correct address, and then tap Test.
The Connected to the Web Service popup window appears.
2. Tap .
3. Tap Save.
The AcuityLink Clinician Notifier splash page appears.
Note If a Cannot Connect to Server popup window occurs, suspend this re-launch
attempt. Consult with your facility’s IT department to ensure that the mobile
device association and connection settings are correct.
These settings are indicated in the AcuityLink Clinician Notifier Installation
Instructions included on the AcuityLink Clinician Notifier Software Installation
disc.