Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual - Manual (Page 10)

10
Accessories and Optional Equipment
Installation Sleeve
Each Wine Guardian system includes an EasyMount™ installation sleeve to be used in the
mounting of the system through-the-wall at the desired location. The sleeve is essential for the
proper support of the Wine Guardian system and ease of installation. The maximum dimensions
of the wall opening should be 386mm wide by 413mm high.
For proper operation of the system, including drainage and undue noise and vibration, the
Installation Sleeve must be mounted level within the wall cutout and securely fastened to the
wall studs on either side of the sleeve as shown on page 18.
Extended Compressor Warranty
The Wine Guardian uses only the best commercially available compressors on the market.
However, since the compressor is the single most expensive component in the system, it is
recommended that you purchase the extended, five-year warranty option.
Duct Collar Adapter
An optional duct collar kit is available for ease in directing the warm condenser air away from
the through-the-wall unit mounting. The kit includes one (1) duct collar, 15-feet of 6-inches
round flexible ductwork and two (2) tie wraps for connection of the ductwork to the duct collar.
The kit does not include connections at the tie-in point to the remote location or outdoors.
Remote Temperature/Humidity Controller
The remote temperature/humidity controller (Remote Interface Controller) is intended to provide
a means for user interface at a remote location. The controller can be used as a remote
sensor/controller mounted within the wine cellar remote from the Through-the-Wall system. The
controller can also be used as a remote indicator (without sensor) mounted directly outside of the
wine cellar of the residence or building. The Remote Interface Controller includes a backlit face
for temperature and humidity indication along with controller set-up and operational functions.
Remote Temperature/Humidity Sensor
The remote temperature/humidity sensor is intended to provide a means of sensing one or more
locations within the wine cellar ands designed to work in conjunction with the Remote Interface
Controller or Local Interface Controller integral to the Wine Guardian Through-the-Wall system.
Multiple sensor readings are averaged and controlled to a single point. The sensors do not have
any temperature or humidity indication and must be mounted within the wine cellar.
Humidity Option
An optional stand-alone humidifier comes fully assembled and tested for field installation. It
automatically adds moisture into the cellar by the evaporation of water over a distribution pad.
See page 21-22 for key installation information.
Humidifier Connection: You can locate the low voltage connection for field
optional remote humidifier on side of control panel on the wine cellar side of
the WG cooling unit. The optional humidifier comes pre-wired to fit directly to
this connection for the WG unit to control cellar humidity level desired.