Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual - Manual (Page 15)

15
Hot Parts Hazards
Electric Resistance heating elements (if equipped) must be disconnected prior to servicing.
Electric heaters may start automatically, disconnect all power and control circuits prior to
servicing the system to avoid burns.
Moving Parts Hazards
The Motor and Blower must be disconnected prior to opening access panels. The motor can start
automatically. Disconnect all power and control circuits prior to servicing to avoid serious
injuries or possible dismemberment.
The fans are free-wheeling after the power is disconnected. Allow the fans to stop completely
before servicing the system to avoid cuts or dismemberment.
Rotating Fan Blades are present in the Wine Guardian system. Sticking a hand into an exposed
fan while under power could result in serious injury. Be sure to use the Lockout/Tagout procedure
when working in this area or remove the power cord.
Equipment Safety Interlocks
There are no electrical safety lockouts installed within the system. The power cord attached to the
control box must be disconnected from the power sources prior to working on any part of the
electrical system.
On/Off Switch
To shut down all high volt power internally, the power cord must be removed from power outlet.
Energy Type Voltage
Hazard ...................................................................... Electrocution, electrical burns and shock
Magnitude .................................................................................... 230 Vac, 1 phase, 50 cycles
Control Method ...................................................... Disconnect power cord and On/Off Switch
DANGER

Never reach into the system while the fan is running.

Avoid risk of fire or electric shock. Do not expose the system to rain or moisture.
WARNING

All supports for the system must be capable of safely supporting the equipment’s weight
and any additional live or dead loads encountered.

All supports for the system must be designed to meet applicable local codes and ordi-
nances.

Do not remove access panels until fan impellers have completely stopped. Pressure
developed by moving impellers can cause excessive force against the access panels.

Fan impellers continue to turn (free-wheel) after the power is shut off.