Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual - Manual (Page 9)

9
Standard Specifications
The Wine Guardian System Contains
 A capillary tube expansion to control the flow of refrigeration into the evaporator coil
 A filter dryer to keep the refrigerant clean and free of contaminants
 Dual factory mounted plastic supply/return air grilles for evaporator and condenser air
movement
 Movable supply air louvers for side-to-side directing of cold air into the wine cellar
 A manually reset, high-pressure switch on the condenser discharge to protect the
compressor from high pressures
 Environmentally friendly-134a refrigerant
 An internally/externally mounted digital electronic control with many user-controlled
settings
 Auxiliary drain port connection at condenser end of unit
All exterior framing of the Wine Guardian is powder coated, 0.063" gauge aluminum to prevent
rust and corrosion. All coils are copper tubes with aluminum fins. The evaporator is coated with
an “E” coat finish to prevent premature corrosion. The system uses an internal drain system to
remove excess moisture and does not reintroduce it back into the cellar. An auxiliary drain port
is located at the condenser end of the unit should there be a need to physically remove the
excessive moisture.
Each system is provided with a pre-wired and tested electronic digital thermostat (local user
interface) as standard, or an optional remote mounted thermostat (remote user interface) in the
wine cellar. The thermostat has multiple control functions for the fan, operation, cooling (if
equipped), and maintaining humidity.
Compressors are self-lubricating, permanently sealed, hermetic reciprocating type compressors,
with internal overload protection and capacity start with a minimum of one-year manufacturer’s
warranty and an optional five-year warranty. Compressors are mounted on rubber-in-shear
isolators to reduce noise and vibration.
Electric power is supplied by a single, factory-furnished cord and plug that can be connected on
the cellar side or the condenser side of the unit. Units are shipped from the factory with a plug
attached on the condenser side. All controls are 24-volt supplied from an internal transformer.
IMPORTANT
Design and specifications are subject to change without notice