Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual - Manual (Page 24)

24
Installing the Thermostat and
Communication Cable
The Wine Guardian Local Interface Controller is a
combination temperature and humidity controller with
single stage cooling, heating and humidifier control. Each
Wine Guardian Through-the-Wall unit is supplied with a
Local Interface Controller as an integral component of its
assembly. It is installed at the factory and tested prior to
shipment.
In most applications the Local Interface Controller is
adequate for proper wine cellar monitoring and control.
However, sometimes multiple points of sensing and
control are ideal, especially for odd-shaped rooms. The
Wine Guardian Remote Sensors offer the ability to sense a
maximum of three locations and control to their average
condition.
Wine Guardian also offers the option of monitoring the
wine cellar conditions from outside of the wine cellar or
from another room in the home or building through the use
of our Remote Interface Controller.
See below for remote sensing and Optional Remote
Interface Controller installation details.
Mounting the Optional Remote Interface Controller
1. Disconnect the communication cable from the back of
Remote Interface Controller. (Fig. 1)
a) Install the communication cable within the wall
and/or ceiling structure of the wine cellar to the
desired controller mounting location.
b) Mount the remote interface controller on a solid
surface away from doors, corners, air outlets, drafts or
heat generating equipment. Do not mount the Remote
Interface Controller directly on an outside wall or wall
adjacent to a boiler room.
Local Interface Controller
Optional Remote Interface Controller
Fig. 1