Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual - Manual (Page 20)

20
You must then move the red voltage switch in the opposite direction as from the factory to move
the internal power from the condenser side to the wine cellar side. (See Illustrations)
Grilles
Factory supplied and installed for proper air intake and discharge for optimal system
performance.
Mounting the System
Follow the steps below for installation of the Wine Guardian Through-the-Wall unit.
Step 1
Find wall stud locations. If both wine cellar side and finished basement
side of walls have drywall already installed it is important to locate the
wall studs in the area chosen to mount the Through-the-Wall system. Use
of any high quality stud finder is recommended for locating the center and
edges of the wall studs on the wine cellar wall. Once located, the stud
edges should be clearly marked prior to following Step 2 below.
Step 2
Preparing wall penetration for Installation Sleeve. Mark the penetration
dimensions on the wall (wine cellar and finished basement side) at the
desired mounting location for the Wine Guardian Through-the-Wall unit.
Keep in mind the ideal height should be at eye level to the user. The unit
controls should be reachable upon installation completion. The wall
penetration should be no more than 368mm wide by 413mm high stud-to-
stud dimension so modifying stud locations is not required.
CAUTION
RISK OF PERSONAL INJURY OR DAMAGE TO EQUIPMENT
Ensure that the area chosen does not have electrical or plumbing interference within the wall
or along the outside of the wall. Failure to do so could cause property damage or personal
injury. If the wall does include electrical wiring or plumbing DO NOT CONTINUE. Contact a
qualified electrician or plumber to relocate these services or choose an alternate location for
mounting the WG system.
Voltage Switch : It is set from factory to supply power to the
line cord wired to condenser side of unit. If you need power
cord moved to wine cellar side of unit, you must move the
switch to the opposite direction from factory setting, which
now will be facing the evaporator side fo the unit (in wine
cellar).