Voip-600, Series phone configuration / operation manual – Talkaphone VOIP-600H Single Button Help IP Call Station User Manual

Page 17

Advertising
background image

VOIP-600

Series Phone

Configuration / Operation Manual

Page 17 of 94

Rev. 9/17/2014

Copyright 2014 Talk-A-Phone Co.

• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.

All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.

4.4.2. SIP Settings

This page is used to configure the phone number, SIP registrars and outbound proxy details.

Login → Network → SIP Settings

Figure 6 SIP Settings

To configure SIP settings:

1.

Enter the Phone Number (number used to call from other SIP endpoints).

2.

Enter the Fully Qualified Domain Name or the IP Address of the SIP Gateway/Proxy. Secondary
and Tertiary FQDN or IP Addresses can be assigned for failover. There is a 30 character limit for this
field. If Secondary and Tertiary Registrars are not used, then voip500.local is the default placeholder.

3.

Check or Uncheck Register to enable or disable the SIP registration.

4.

Enter SIP registrar details: (Secondary and Tertiary details can be assigned for failover)

Username: This is an optional field however it is required when Authentication is enabled on the
SIP registrar. Valid entries include alphanumeric and special characters (

‘*’, ’.’, ’-‘, No spaces

allowed)

Password: This is an optional field however it is required when Authentication is enabled on the
SIP registrar.

Valid entries include alphanumeric and special characters (‘*’, ’.’, ’-‘, No spaces

allowed)

IP Address and Port: Configure the IP Address and Port of the SIP registrar on which you want
to register the phone. Default port is 5060. Valid port range is 1024-49151.

Re-registration Time: Configure the registration refresh time. On expiration of this time interval,
the phone automatically sends a new register request to the registrar. Default re-registration time
is 3600 seconds. Valid range is 10-14400 seconds.

1

3

4

6
4

2

5

Advertising