Talkaphone VOIP-600H Single Button Help IP Call Station - Manual (Page 20)

VOIP-600 Series Phone
Configuration / Operation Manual
Page 20 of 94 Rev. 9/17/2014
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4.5.2. Phone Settings
The Phone Settings page allows you to configure the VoIP protocol for communication, auto answer mode of
operation, prioritization between phone and paging operation, and caller ID settings.
Login → VoIP → Phone Settings
Figure 8 Phone Settings
To configure the phone settings:
1. Select Enable if you want the VOIP-600 to answer any incoming calls automatically (only applicable to
VOIP-600 phones with a built-in hands-free speaker).
When this option is set to Disable, incoming calls are answered by either picking up the handset or by
pressing any button configured as a hook switch. If the VOIP-600 does not have a handset option and
cannot be configured with a hook switch button, a manual answer method will not be available.
2. Select and assign the priority between Phone Mode and Paging Mode . When the “phone mode” has
priority over the “paging mode,” the incoming paging request is processed when the phone is in idle
state. When the phone mode has a higher priority, all paging operations stop and phone operations
are processed. When the paging mode has a higher priority, all phone operations stop when the
paging mode has a higher priority and the paging request is processed.
3. Select Enable or Disable to transmit a Caller ID over the network or to peers. This field allows
alphanumeric characters only. Some phone systems require Caller ID assignment from within the
phone system management.
4. Click Apply to save settings.
1
2
3
4
4