Talkaphone VOIP-600H Single Button Help IP Call Station - Manual (Page 31)

VOIP-600 Series Phone
Configuration / Operation Manual
Page 31 of 94 Rev. 9/17/2014
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4.6.4. LEDs
The LEDs configuration page allows for the configuration of LED #3.
Login → Devices → LEDs
Figure 15 LED Settings
To configure the LEDs:
1. Enter the Key code sequence and duration for LED #3 to be activated.
i. Key code sequence to be used b y the remote side to activate LED #3
6
.
ii. Click the drop-down menu to select the duration for which LED #3 should remain active (i.e. ENTIRE
CALL (deactivates after the termination of the call), CONTINUOUS (activated indefinitely until
deactivated by deactivation event), or CUSTOM (activated for the specified duration in seconds).
2. Enter the Key code sequence to be used by the remote side to deactivate LED #3
7
.
3. Click Apply to save settings.
6 If DTMF Authentication is enabled (see section 4.8) the Guard Access Code will need to be entered before any other code may be used.
7 If DTMF Authentication is enabled (see section 4.8) the Guard Access Code will need to be entered before any other code may be used.
1
3
4
2