Talkaphone VOIP-600H Single Button Help IP Call Station - Manual (Page 40)

VOIP-600 Series Phone
Configuration / Operation Manual
Page 40 of 94 Rev. 9/17/2014
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
ii. Auxiliary Input Events

Configure the Secondary Digital Output activation on activation/deactivation of Auxiliary Input
#1, Auxiliary Input #2, and Auxiliary Input #3, during an Active call or while Idle.
iii. Remote Side Key Codes

Configure the Key Code sequence to be used by the remote side to for activation of the
corresponding Secondary Digital Output
12
, after the defined duration of time has elapsed.
iv. Local Key Codes

Configure the Key Code sequence to be used by the Local User for activation of the
corresponding Secondary Digital Output, during and Active call or while Idle.
v. On Selected Events

Configure the Secondary Digital Output activation on selected events as specified above.
vi. On Call Transfer

Configure the Secondary Digital Output activation on call transfer.
3. Click Apply to save settings.
Note You cannot use the same event for activation and deactivation of the same Digital Output.
12 If DTMF Authentication is enabled (see section 4.8) the Guard Access Code will need to be entered before any other code may be used.