Talkaphone VOIP-600H Single Button Help IP Call Station - Manual (Page 63)

VOIP-600 Series Phone
Configuration / Operation Manual
Page 63 of 94 Rev. 9/17/2014
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
5.9. Recording Voice Messages
The VOIP-600 Series Phone has the capability of recording up to six different voice messages (each up to
one minute in length).
To record a voice message on the phone from the remote side:
1. Call the VOIP-600 Series Phone.
2. Once the call is answered, enter the DTMF authentication code. The default DTMF authentication
code is *4**.
3. To initiate voice message recording, press *91*<message num>* where message num is from 0-5.
The voice message programmed for message num 0 is used for the “Key Press to Answer” feature.
4. After the single beep, begin recording the voice message.
5. Press any key to stop the voice recording.
Note The maximum voice message length is one minute. If no key is pressed within one minute or the call is
disconnected, the voice message recording stops automatically.
5.10. Previewing Voice Messages
To preview your recorded voice messages from the remote side:
1. Call the VOIP-600 Series Phone.
2. Once the call is answered, enter the DTMF authentication code. The default DTMF authentication
code is *4**.
3. To initiate voice message previewing, press *92*<message num>* where message num is from 0-5.
The voice message programmed for message num 0 is used for the “Key Press to Answer” feature.
4. After the single beep, the voice message will begin playing.
5. Press any key to stop the preview.